Step - 1

Refer to the labelled sheet for making the Chandrayaan model

Step - 2

Cut the part labelled as Vikram to make the main body of the lander using scissors

Step - 3

Cut along the solid lines to make the ramp using scissors

Step - 4

Paste the flaps using Fevicol A+

Step - 5

Cut the Ring using scissors, Roll It into Circle and paste it with Fevicol A+

Step - 6

Paste the Ring to the base of Vikram, let it dry.

Step - 7

Cut out the booster template from the sheet finely

Step - 8

Roll the template in a conical shape as shown in the image and paste the edges using Fevicol A+

Step - 9

Cut the 4 legs using scissors.

Step - 10

Fold and paste them using Fevicol A+

Step - 11

Paste them on the 4 triangles marked at the base of Vikram.

Step - 12

Cut the 2 Solar Panels using scissors

Step - 13

Paste them on the sides of Vikram on the marked spots using Fevicol A+

Step - 14

Cut the dome, by using scissors

Step - 15

Fold and paste it on the top of Vikram, by using Fevicol A+

Step - 16

Cut the part labelled as Pragyan to make the main body of the rover, by using scissors

Step - 17

Fold along the lines and paste it by using Fevicol A+, let it dry, Measure and cut 3 toothpicks to a length of 4cms, along with it cut the 6 wheels roll them around by using Fevicol A+,let it dry

Step - 18

Roll them around the two ends of the toothpicks,by using Fevicol A+, cut the 2 Base Strips and place them horizontally over the toothpicks,then paste them in the gap between toothpicks,by using Fevicol A+. This will allow the wheels to move

Step - 19

Cut the Solar Panel using scissors

Step - 20

Paste it on the top of Pragyan. Your rover is ready

Step - 21

Cut the flag and paste it on the toothpick, roll the Flag strip around the foot of the toothpickand paste it on the top of the Vikram lander. Your Chandrayaan 2 is now ready to land on the moon!